Xbox
Michigan - Pike Alley
Green Rod Stand - Various Setups
About 70% of the time, my rods on holders do not give any indication when a fish "is on". I know it is in this mode because all i get is bait eaten or lost message, but if I inadvertently pick up the lines there is a fish on with no prior indication. So there is a fish not but no movement indication so I dont know to pick up the rod.
Bobber on Rod Stand: If I watch closely the bobber will "blink" (a very small instantaneous position change.) And then the bobber stays fixed in one spot instead of the normal floating around movement , but no indication of a fish on. If i pick up rod at this point a fish is on every time. Also, when a fish "is on" a bobber rod and im reeling in and then decide to put it back on the rod stand, the bobber sits still as if the fish completely stopped moving.... If don't notice at some point I will get Lost Bait Message
Bottom Rod on Rod Stand: No indication of bite: line doesn't move and bells do not sound. Typically when there is a lot of activity at cast point (splashing/waves) i will get fish on within about 10 sec. In the bugged sate, there is no line movement nor bell indicator. But, if I pick up line after this indicated water activity then there is a fish on. If I don't notice water activity i will just get Lost Bait message.
Bobber or Bottom in hand: Rods in hand always act as normal even when ones in rod stand are not acting correctly.
Typically what i do at this point is to reload app. Sometimes reloading works sometimes i have to do it again. Also, I have seen this happen when it is good when I first log in and at some point it stops working. I use the exact same equipment and location on PC and do not run into this issue. I am not high enough level to know if this happens with power rod stands.